IanguageInstalling an IP65 sheet metal enclosure efficiently requires precision to maintain environmental protection and structural integrity. Follow these three essential steps for optimal results.
Step 1: Verify Site Compatibility
Assess mounting surface flatness and load capacity before positioning. Ensure adequate clearance for cable entry and ventilation. For enclosures like BaoXuan, check gasket alignment with the surface profile to prevent compression gaps.
Step 2: Secure Mounting & Alignment
Fix the enclosure using corrosion-resistant hardware matched to your surface material (concrete, steel, etc.). Tighten bolts gradually in a cross pattern to distribute pressure evenly. BaoXuan models feature pre-tapped mounting points for consistent torque application and reduced warping risk.
Step 3: Seal Entry Points & Validate
Install cable glands with dual-lock nuts on designated knockouts, applying thread sealant for watertight compression. Confirm gaskets are debris-free before closing. Conduct a 12-hour water spray test to verify IP65 integrity. BaoXuan gasket channels are precision-stamped for uniform compression, exceeding ingress protection standards.
Using BaoXuan enclosures simplifies compliance through standardized mounting systems and tested sealing geometries. Document installation details for future maintenance audits.
